With the wide application of pipeline pumps in chemical, pharmaceutical, food delivery and other industries, the maintenance of pipeline pumps has received more and more attention. Today, the editor will introduce you to the maintenance tips of pipeline pumps, as follows: Pipeline pump maintenance: Scrub all parts to be installed. Install the mechanical seal on the motor main shaft, and add a small amount of clean turbine oil or No. 20 engine oil to the surface where the dynamic and static rings of the mechanical seal match.
Pipeline pump maintenance tips: Install the impeller and tighten it with the impeller nut. Pipeline pump fault maintenance: Fault maintenance during pipeline pump operation: The inlet pipeline must be filled with liquid, and the hot water pipeline pump is prohibited from running for a long time under cavitation conditions. Check the motor current value regularly, and it must not exceed the rated current of the motor. After the hot water pipeline pump has been running for a long time, due to mechanical wear, when the noise and vibration of the unit increase, it should be stopped for inspection. If necessary, the vulnerable parts and bearings can be replaced. The overhaul period of the unit is generally one year.
Mechanical seal fault maintenance of pipeline pump: Mechanical seal lubrication should be clean and free of solid particles. It is strictly forbidden for mechanical seals to work under dry grinding conditions. Before starting, you should turn the Triumph hot water pipeline pump (motor) for a few turns to avoid graphite ring breakage caused by sudden starting. The seal leakage tolerance is 3 drops/minute. Otherwise, it should be checked. In the process of using pipeline pumps, it is impossible to be smooth sailing, and various problems will often be encountered. Therefore, this requires us to do a good job of maintenance of pipeline pumps when using them, which can not only ensure the normal operation of the equipment, but also extend its service life.